Running cost comes down to wattage, hours and your rate. In New Hampshire the rate is 27.33 cents per kWh, which is 48.2 percent above the national average. Here is what that means for a electric water heater.
A electric water heater drawing 4,000 W costs $1.09 per hour in New Hampshire. Run 3 hours a day that is $3.28 daily, $98.39 a month and $1,197 a year, which is $389 more than the same appliance at the US average rate.
Electric water heater cost at New Hampshire rates
Change any box. The result updates as you type.
Planning estimate. The rate box is prefilled with a regional average; the figure on your own bill is the one that matters. Power is draw while running, not while switched on.
Cost by hours used per day in New Hampshire
| Hours/day | Energy | Per day | Per month |
|---|---|---|---|
| 1 h | 4.00 kWh | $1.09 | $32.80 |
| 2 h | 8.00 kWh | $2.19 | $65.59 |
| 4 h | 16.00 kWh | $4.37 | $131 |
| 6 h | 24.00 kWh | $6.56 | $197 |
| 8 h | 32.00 kWh | $8.75 | $262 |
| 12 h | 48.00 kWh | $13.12 | $394 |
| 24 h | 96.00 kWh | $26.24 | $787 |
Cost by wattage at 27.33 cents
| Rated power | Per hour | Per day | Per month |
|---|---|---|---|
| 3,000 W | $0.82 | $2.46 | $73.79 |
| 3,800 W | $1.04 | $3.12 | $93.47 |
| 4,500 W | $1.23 | $3.69 | $111 |
| 5,000 W | $1.37 | $4.10 | $123 |
| 5,500 W | $1.50 | $4.51 | $135 |
Find the row matching the nameplate on your own unit. Within a single appliance category the spread is often wider than the difference between categories, so the label is worth reading.
Water heating in New Hampshire
Incoming groundwater temperature sets how hard the element works, and it is colder in winter everywhere. New Hampshire sees a wide seasonal swing, so winter water heating costs meaningfully more than the annual average suggests. A heat pump water heater cuts consumption to roughly a third and works particularly well in a warm garage.
Why New Hampshire pays what it does
New Hampshire has a competitive retail electricity market, so the rate used here blends households on the utility default with households on shopped supply plans. If you have never switched supplier you are probably on the default, which is usually the more expensive side of that blend. Only the generation portion of your bill changes when you switch; delivery and outage response do not.
At 27.33 cents, New Hampshire ranks 43 of 51 from cheapest to most expensive. The Northeast regional average is 25.91 cents. Roughly half of any residential bill is transmission and distribution rather than generation, which is why rates keep climbing even when fuel prices fall.
How this compares across the country
The same electric water heater on the same schedule, in the cheapest and dearest states:
| State | Rate | Per month | Per year |
|---|---|---|---|
| Idaho | 12.35¢ | $44.46 | $541 |
| Utah | 12.96¢ | $46.66 | $568 |
| New Hampshire | 27.33¢ | $98.39 | $1,197 |
| California | 33.25¢ | $120 | $1,456 |
| Hawaii | 52.00¢ | $187 | $2,278 |
Lowering the number in New Hampshire
- Set the thermostat to 120 degrees. Many ship at 140. Every 10 degrees cuts standby loss by around 4 percent.
- Insulate the first six feet of hot and cold pipe. Cheap, and it stops heat walking out through the plumbing.
- Fix dripping hot taps. A hot tap dripping once a second heats water that goes straight down the drain.
- Flush sediment annually. Sediment insulates the lower element from the water, so it runs longer.
- Consider a heat pump water heater. Roughly a third of the energy for the same hot water.
- In New Hampshire, air sealing pays back faster than equipment upgrades. A long heating season multiplies every draft, and sealing is cheap compared with replacing hardware.
Offsetting it with solar in New Hampshire
This load uses about 12.00 kWh a day. Covering that would take roughly 9 standard 400 W panels at typical sun hours, an array of about 3.60 kW. Because it offsets electricity worth 27.33 cents rather than the national 18.44 cents, the same array is worth more here than the national payback figures suggest.
Water heating is the single best use of surplus solar, because the tank is a battery that stores heat instead of electrons. Diverter controllers exist specifically for this. Full sizing, including battery and inverter requirements, is on the solar sizing page for this appliance.